K-2 Pickling Spray (Semi-Gel Form)



Spray is used to clean large fabricated equipment of Stainless steel e.g. Vessels equipment, internals & external surfaces of pipes by a pressurized spray bottle or pump.

AREA COVERED

Spray form covers 40-50 sq.ft. of an area with 1 kg. of the chemical.

APPLICATION PROCEDURE FOR SPRAY
  • Add 50 gms of SI. 56 Degreaser to 1 ltr. of water (5% w/v.). Apply solution on the surface for 10-15 minutes & then wash thoroughly and allow the surface to dry.
  • Spray is to be sprayed on the S.S. Surface with a pressurized plastic spray bottle or spray pump.
  • After spraying leave it for 30-60 minutes then scrub the surface with a plastic bristled brush.
  • Then wash the surface thoroughly with high-pressure water and allow the surface to dry.
  • Next, apply Passivation solution and leave it for 20-25 minutes.
  • Finally rinse the surface thoroughly with demineralized water and dry.

Note:
Chloride content in rinse water should be less than 50 ppm.
Shake the products well before use.
Do not apply the products under direct sunlight.
Passivation is a must after every pickling process.